- Brake Booster....
- Making a Lemans fuel cap safe?
- F&R Nudge_Bars
- EFI Plumbing... Return Line.
- Dash cover material
- Nine Inch Conversion
- Intake question!
- fuel level sending unit wiring ???
- Motor Mounts - Thread that never dies..
- Pictures of your Classic Roadsters Cobras?
- Fan connections for CR with computer control
- Selling Cobra
- Help with radiator mounting
- Fuse Block???
- Fuel pump mounting location options??
- 4 - point roll bar
- Front coilovers for the CR
- 5.0 EFI Conversion
- (new) Seats
- master cylinder question
- Any new talk of an IRS conversion
- Hey DV
- Hood and Deck lid Gas shocks?
- Ac/ Heater question wheres the heat.
- Oil Heater/Cooler????
- MCO..Manufacturers Certificate of Origin?
- Dv
- Engine cooling
- Hey Don Scott....Me Again!!!!
- Help with clutch fork
- Riddle me this Batman
- R&R Master Cylinder
- wanted cr front loop
- Need front end Wheel alignment Help!
- Installing the steering column teflon bushing
- what trans parts do I need?
- Hey...Don Scott!!
- Need some minor parts! For inspection!
- Carb problems help Don, anyone
- Fuel sender hassles, still
- T56, Classic Roadsters....
- original 289 FIA wheels ???
- Old Style Heater Assembly
- Anybody got a softop or Tonneau cover!
- Bellhousing install
- Aldan Shock
- Viper V-10 in Classic Roadsters Kit....
- Clutch cable... How????
- Cobra Weight Distribution....
- Master Cylinder question
- More Brakes
- Does anybody have an extra rear deck light?
- Over Flow Tank Question?
- Front spring lbs.
- steering column wiring help
- Carburetor Problem(s)
- rear Shocks need help.
- Dvsf Iii
- Windshield Wiper Motor
- Stop/Tail/Parking light configuration
- Hot, Hot, Hot
- Viper V-10 question
- Valve Stem Seal Dia.
- Stripe Dimensions
- Timing Chain Suggestions?
- Hellooooo Don Scott......
- Piston Head Description
- H.O. or NO?
- Fuel Gauge Problem
- DV-Sidepipes
- Oil Overfill what does it do?
- Can you modify the Speedo Cable?
- Cam Bearing Change??
- Rear Main Leak
- Pedal assembly
- Ignition wires identification
- Broken Clutch Cable
- DV...Need a part number.
- Master Cylinder help
- Mustang II Master Cylinder + Rear Versailles brakes = little rear brakes
- Ford Engine Harness Install ?'s
- YeeeeHaaaaw!
- Cooling
- Brake Questions
- Chevette Column Question?
- Some help with a neutral safety switch
- Need sidepipes!
- Motor Mounts
- Petek...and to all that need a picture!
- Ok Guy's...it's not working?
- need advice on engine selection
- Need Help with ignition.
- CR Engine Wiring
- driveline offset....
- Lokar Auto Shifter Question
- Need some help on ignition wiring
- Fuel System Questions
- Rear Coil Overs (hey Don)
- Need help with the wiring for the lights.
- HC and CO ranges for fine tuning.
- Classic Roadsters Running Special?
- Anybody have some extra parts?
- remote oil filter location question
- Somebody check me on this...
- Genada vs Mustang II Brakes
- MII front end alignment problem solved
- CR parts
- Has anyone installed air vents?
- Oops !
- Question on lowering engine and front end
- DV - What wheels are on DVII?
- DV, Dscott...anybody...Need Help!
- SF location in London
- Fuel cell needed. which one fits
- Stewart Warner Quality?
- Motor mount question
- Lokar Throttle Cable
- Where can I get the stuff to wire up my 95 EFI 5.0
- Steering Column Question
- Shock Question
- Sun visors ?????
- CR Dash Wiring ??'s
- Wind Wings
- DV...Need help with the Summit Adj Proportioning Value.!
- Can you help a brother out?
- DV... Need help .
- Bent axles?
- Aluminum Nose Cone...I didn't forget
- dash ignition switch ? for DV
- No CR at Carlisle?
- 393 Stroker Balance
- Gauge question??
- My sky is falling!
- TFS head valve guide seals
- Distributor drive gear life expectancy
- Fuel tank sender question.
- Upper control arm rotation kit
- Sway Bars
- My Cobra is back home
- The saddest day
- Need Ford Engine Harness for CR
- Dashboard Removal
- DV...Dash wiring help needed!
- Radiator scoop (upper and lower)
- speedo.
- Vintage Air Heat/Defrost Install
- Dim CR headlights
- Alternator question? fo Dscott or DV
- Brake rotor backing plates
- brake lines
- Need Help! Stewart Warner Tach!
- 8.8 diff
- Roll Bar Kick
- What gears to use?
- Engine vibration question
- Headlight bucket and Trim rings
- Front sway bar question?
- Front disk brake/contol arm rub
- CR 302 motor mount fix
- Motor mounts........again
- Firewall Modification
- econo-fix for front suspension
- Tonneau Covers Et All
- EFI Intake Manifolds
- Bcak pressure and beating a dead horse!
- Classic Nudge bars
- rims and tires
- Front Nudge bars and bumper
- Upgrades
- Roll Bar measurements
- Front suspension (again)
- 95 ford 5.0 mounts
- Ceramic Coating
- Another spring & shock question, front this time.
- DV II
- Question for don Scott or DV about Shocks
- Rack and Pinion Steering
- Body Style Change
- Shelby American Cobra VIN number
- Help!!!!decisions, decisions
- Firewall Gelcoat Cracking
- 95 FI 5.0 engine wiring harness
- Aerodynamics of a Turd
- brake adjustment
- Door latch and rear latch
- Minor adjustments and suspension adjustments
- Front suspension again
- Bolt on's
- Temporary Insanity
- Front springs for 460
- Opinion of Demon Carbs
- IRS and Classic
- "Cosmetic" roll bar!? Don't think so!
- Fuel Sending Unit
- seat and seatbelt mounts
- Suspension questions
- Holley jetting
- MII front end alignment
- handling ?
- big block vs small block
- Tonneau Cover
- Trunk Mounted Battery
- Engine Wiring
- Lucas windshield wiper question
- Sm_Block to Bg_Block X_Change
- Alignment Settings
- Ride quality
- Hey DV (Brake help)
- knock off
- Contact Info and Random Thought
- Rear suspension
- Need Help with Top installation!!
- Keeping cool
- Panhard Rods
- Classic Roadster Age