- Thanksgiving Treat
- Distributor to fit BBF with dual quads
- On It's Way!
- Jell Coat Crack
- What paint did you use on your Cobra's frame
- 15" compomotive wheel
- Replacing seal in a 9" Ford
- Lexan Replacement windshield
- Run at Watkins Glen
- Upgrading GM Metric Brakes
- Need a few parts
- 2nd Chance
- Replacing a side pipe muffler
- rear end
- VW Turn Signal
- Radiator Bracket
- Wheel Adapter
- Need Comp Automotive wheel
- Choice of insulation
- Control Arm Safety Tip
- brand new guy
- Noise Insulation
- Using Manual MC with Power Poster
- Gauges, dash layout
- Last few parts
- 1966 428 flywheel
- NYS Registration Process
- How much clearance
- How to hood hinge support before your body cracks
- Frustrated with my brakes
- Enterprise rent a pickup?
- Le Mans top
- Trunk Complete
- Stripes
- ### Nearly ready
- Converting to Two MC's
- trunk area
- New Hood Support
- AMICA Certification
- Carpet Install
- NYS Registered A&C Cobras
- Caster adjustment
- best type of insulation
- Hot quick jacks
- Distributor, mechanical or vacuume advance
- Dual MC for GM metrics and Ford Explorer rear brakes
- Up and Down the Block!
- towing your Cobra
- brake warning light/NJ
- Almost ready for a drive up and down the street
- Pan Hard Bar from A&C
- front holes for bumpers/finish line gromets
- Finally Legal
- steering shaft
- Assembly manual
- Side Louvers
- keeping hot air out of the footbox
- Does AC give you the option of buying your kit in steps?
- 289 and t5 question
- First accident with the cobra today
- Steering Column
- best way to install carpet over dynamat
- Exhaust hangers
- dynamat vs hushmat etc!
- higher speed problem
- First Good Ride
- i can post pictures?
- Ohio London Show
- side louvers
- 4 link 9" set up
- Lost the rear end of my car. QuadMat install
- Strut arm issue
- Gelcoat color
- A&C Build
- Need Brake Help
- Answers for Ron
- 429cid w/4-spd toploader & lakewood bellhousing
- 67 Roadster Questions
- Electrical Question
- Rear end/wheels max width HELP!!
- Got my Pa. title and plates today
- Metric brake problems
- 1.75" roll bar bezzles
- AC Guys, Help!
- Finally gave Sonny a deposit....
- Another A C gets aluminum
- Some weekend aluminum work
- Nose insert
- Sylvania 6014 that come with the kit.
- 289 FIA plaque
- Replacing Upper and Lower Ball Joint Boots
- I NEED A MGB emergency brake handle
- location of remote oil filter
- Side pipe dent repair how to
- Convertable Tops for a cobra
- Axle vent
- Stripe how to for A&C body and others
- Picked up my frame
- Axle flange bolts
- Panhard Bar & Wheels
- electrical problem w/horn & VW turn signal
- Next one getting preped for paint
- Brake booster pocket mold finaly made
- The latest paint job & how I do the stripes
- Trying something new Side pipe urethane mounts how to
- Front Rotor Help
- thank you Eddytheb
- how did you install your seatbelts
- Rear end assembly
- Body Mounting
- Ordered today, Finally!
- new to site,question
- head light rings
- Carbon Fiber Dash?
- Trans Frustration
- Clutch master cylinder
- Hiding Wires
- Greetings, another ac cobra ordered!!
- Heaters
- steering column
- Clutch
- Clutch Fork
- Rear springs
- body alignment/ride heigth
- Body Mount
- Steering Extension
- Other Sources
- How much clearence for sidepipes
- Help JerryW
- Hanging doors
- 4.6 Motor
- Toploader Shifter Problem
- Parts id
- Having a good spring?
- wiper arms
- seat belts
- A&C brakes & master cylinder
- Disc Brakes
- corvette pedal box
- slight upgrade in bezels.
- Looking for a soft top supplier.
- Road legal in KY
- Cool wing mirrors
- How did you line up the bumper holes?
- A&C Whaddya Think?
- power brakes yes or no??
- Cermakrome small block headers
- Engine Paint for 427 ford
- painter body
- Who built the KCC Cobra replica ?
- Emergency Brake Handle
- rolling chassis
- mustang 11 front end toqure spects
- body cracks stress
- Manual windshield wipers wanted
- measuring for driveshaft
- insurance
- 17" on an A & C
- Torque specs
- panard bar
- carpet installed
- A& C Seats.
- cluch slave
- Ground Clearance
- Original RayDot Mirrors
- edelbrock carb
- A&C frame
- rear firewall
- Roll bar mounting
- steering wheel
- Door latch driver side
- painting the body
- roll out with doors on
- 427 engine Temperature.
- 427 RPM at 60 mile per hour
- 631/2 center oiler (solid lifter) Question about oil
- Sidepipe mount.
- Parts I.D??
- Bodys on. Now what?
- Fathers Day Car Show Winner!!!!
- Hesitation during longer runs and oil leak
- brake distribution block
- side pipe cut outs?
- Body height
- back spacing
- FE power'd phila area
- A&C cobra w/ fe motor
- windshield wipers/seats
- Roll Bar question
- spring is in the air
- A&C questions
- Manifold on 351w in A&C
- no sidepipes
- Side Pipe or Header Cracking
- Rear brake options?
- 9" axle bracket order for svo brake
- Hydraulic clutch assembly in Antique an Col.
- Sway Bars
- A&C on Ebay...
- 460 how much horsepower?
- Recommendations for Paint shops
- Title issues
- 272 Y Block parts needed
- Not Cobra, but 1932 Ford project for sale
- pusher fans
- Front rotor issues
- Tonneau Fastner Pattern
- 4 spd Toploader in an Antique and collectable
- Missing one Cooling fan
- 64 427 way too rich
- 64 427 timing
- Motor mounts
- 427 head torque
- Picture of rear roll bar mount?
- 427 spark Plug
- rear end control links
- 427 Blues
- Left front tire rubbing
- Hard top for AC.
- Stewart Warner gages fogging
- Front end shocks and springs
- Wind wings installation problems
- 750cfm
- Frame painting-- POR15
- 3 laps on Watkins Glen raceway
- Steve McQueen's 1963 Ferrari Sold
- Got her Safetied today
- New Cobra
- Looking for a Body Shop
- Carb Linkage
- Door latching
- Is there a unique Motorcars forum in here???
- Overflow container
- Good news. She up and running!!!
- Got her started but not a good finish
- Help!!!-ignition problems-1965-427
- Rear License plate bracket
- Gelcoat/fiberglass cracks
- A&C with top
- First Test Ride and new pictures
- Carrols Autograph
- Interior Question for AC
- Gauges pegged to the right!
- Conver 9" to IRS?
- Adjusting my front coil overs.
- Front Suspension Spacers ?
- Is it offset or backspace?
- Front suspension help
- New Pictures
- For all you gel coat guys....